Klaric – Perfectly matched

Klaric GmbH & Co. KG from Stuttgart specializes in the development of measurement and testing technology for mobile and stationary applications in vehicles or in test benches. Our customers come mainly, but not exclusively, from the automotive sector. We are the specialists for precise measurement of currents, voltages and temperatures in a wide variety of environments. We offer solutions from low voltage to safe measurements in high voltage systems.

For electromobility, we offer everything needed for measuring and testing. The application areas of our measurement technology are very diverse – from hexacopter to eCar.

The advantages of Klaric measurement technology

Test and measurement technology in wide areas: Quiescent, operating and peak currents - three measurements in one module and the same set-up

The KLARIC measuring chain enables the measurement of different operating modes in one measuring device. You increase your productivity without compromising on accuracy.

Dynamic sampling rate: The sampling rate changes automatically, this optimizes the amount of data

Dynamic switching, exactly when the measurement requires it. The dynamic sampling rate allows certain events to be recorded at a higher frequency. Thresholds set in the measuring module are defined for this purpose. When these thresholds are exceeded or undershot, the sampling rate is automatically adjusted. This way, your measurement data is high-resolution when you need it.

Automatic measuring range switching: No preselection of the measuring range necessary, thus considerable time saving

Different measuring ranges in one setting. Due to the automatic switching, the modules are configured once and always run in the optimal measuring range throughout the entire measurement. Thus, users have the highest accuracy without having to intervene during the measurement.

Automatic sensor detection: The calibration values are read out automatically, the setup time is considerably reduced

Plug and Measure! The sensor type and calibration values are automatically detected and stored in the module. The information can be sent via the CAN bus to complete the measurement data. The installation time of the modules and sensors is thus reduced to a minimum.

list_weiss
Request
mail_weiss
info@klaric.de
phone_weiss
+49 711 32 777 6-0
Jobs
cross