Test and measurement technology in wide areas: Quiescent, operating and peak currents - three measurements in one module and the same set-up
The KLARIC measuring chain enables the measurement of different operating modes in one measuring device. You increase your productivity without compromising on accuracy.
Dynamic sampling rate: The sampling rate changes automatically, this optimizes the amount of data
Dynamic switching, exactly when the measurement requires it. The dynamic sampling rate allows certain events to be recorded at a higher frequency. Thresholds set in the measuring module are defined for this purpose. When these thresholds are exceeded or undershot, the sampling rate is automatically adjusted. This way, your measurement data is high-resolution when you need it.
Automatic measuring range switching: No preselection of the measuring range necessary, thus considerable time saving
Different measuring ranges in one setting. Due to the automatic switching, the modules are configured once and always run in the optimal measuring range throughout the entire measurement. Thus, users have the highest accuracy without having to intervene during the measurement.
Automatic sensor detection: The calibration values are read out automatically, the setup time is considerably reduced
Plug and Measure! The sensor type and calibration values are automatically detected and stored in the module. The information can be sent via the CAN bus to complete the measurement data. The installation time of the modules and sensors is thus reduced to a minimum.